The electrical wiring, 2 copper pipes, (one small one a bit larger) foam insulation, thermostat and control box wire all has to go through the bilges. Holes are drilled and epoxied through all the stringers and bulkheads. Oh, and all the 3, 4 and 5 inch ducts had to run from to blower units to the vents. We are close to being almost done with this project.
Though this photo shows Mark in the bilge removing an old bilge hose as I did not have the strength.
Most of the work below the floor was done by me as I fit better in the small spaces – drat!
No comments:
Post a Comment